New Posts New Posts RSS Feed - XCR: Correct Scope Ring Height
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Check for SWFA's No Reserve and No Minimum bid firearm auctions.

XCR: Correct Scope Ring Height

 Post Reply Post Reply   Topic Search Topic Search  Topic Options Topic Options
Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: September/30/2007 at 15:38
Digex View Drop Down
Optics GrassHopper
Optics GrassHopper

Joined: August/25/2005
Status: Offline
Points: 3
I have an old scope I'm moving over to my Robinson Arms XCR and my current Warne Maxima QD Low rings are too small for this setup.  What is the correct height for new rings?

Here's the setup:

RobArms XCR
Leupold VX-I 1-4x20
Butler Creek Scope Covers: 11 Eye / 01 Obj.

Thanks. Any help would be appreciated.
Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: October/01/2007 at 10:17
Dale Clifford View Drop Down
Optics Jedi Knight
Optics Jedi Knight

Joined: July/04/2004
Location: United States
Status: Offline
Points: 5087


depends if you're using BUIS or not, if yes then high, if no then low., the highs make check weld difficult because of the drop in comb of folding stock-- which makes EOtech a really good choice for this gun. in any case powers past 5 are difficult to use and retain the BUIS

 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Similar Threads: "XCR: Correct Scope Ring Height"
Subject Author Forum Replies Last Post
There are no similar posts.
Forum Software by Web Wiz Forums® version 11.10
Copyright ©2001-2017 Web Wiz Ltd.

This page was generated in 0.156 seconds.