New Posts New Posts RSS Feed - Weaver #302 Pistol Mount System
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Check for SWFA's No Reserve and No Minimum bid firearm auctions.

Weaver #302 Pistol Mount System

 Post Reply Post Reply   Topic Search Topic Search  Topic Options Topic Options
Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: July/20/2013 at 19:16
Gene248 View Drop Down
Optics GrassHopper
Optics GrassHopper

Joined: July/20/2013
Location: Tx.
Status: Offline
Points: 2
I recently bought a 186 series Mini 14. Since it is a pre ranch rifle with no scope ring mounts I purchased the weaver 302s mount with rings. I removed the rear sight as instructed and set the rear of the scope mount where the rear sight was located. The front of the mounts has U shaped piece that fits over the barrel just in front of the receiver. When the mount is set into position the rear of the mount partly covers the hole where the rear mount bolt goes thru the ears on the receiver and there are no threads to screw this bolt into. Hope this is not to confusing. I had a 183 series mini 14 back in the 80's and used this same setup but everything just dropped in. Any one have any suggestions how I might make this work?
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Similar Threads: "Weaver #302 Pistol Mount System"
Subject Author Forum Replies Last Post
Pistol Scopes: Weaver vs Burris MP44 Handgun Scopes 2
Weaver flip mount question Djaxson812 Rifle Scopes 2
Weaver K 2.5 60-B And Mount redarrow Rifle Scopes 0
Looking for Advice on mounting system jmr1969 Rings and bases 7
Zeiss Mounting System Prieto9000 Rifle Scopes 3
low rings for weaver mount coyote95 Rings and bases 3
Weaver Scope Mount on Ruger 10/22 Lamorak24 Rings and bases 8
The ultimate Tactical Scope Mounting System, Rifle Scopes 20
The ultimate Tactical Scope Mounting System II HOLLOWPOINT Rifle Scopes 0
S.S.A.L.T. Mounting System FS Roy Finn Optics For Sale 5

This page was generated in 0.313 seconds.