Visit the SWFA.com site to check out our current specials. |
Short neck |
Post Reply |
Author | ||||
Sigundermykilt
Optics GrassHopper Joined: October/16/2012 Location: Uniontown, Pa. Status: Offline Points: 3 |
Post Options
Thanks(0)
Posted: October/16/2012 at 22:04 |
|||
I purchased a Burris AR-332 prism scope for my 20" AR flat top w/A2 stock. I love the scope but can't
get it back quite far enough for proper eye relief. I need maybe 1/2 an inch more to the rear. The scope will work on a Picatinny rail or by removing the base it will fit the carry handle. Does any one make a base that will give me roughly 1/2" rearward movement? Shawn |
||||
Shawn
|
||||
SVT_Tactical
MODERATOR Chief Sackscratch Joined: December/17/2009 Location: NorthCackalacky Status: Offline Points: 31233 |
Post Options
Thanks(0)
|
|||
I believe that scope used ACOG mounts as well. (Do your own research on this because I am not 100% on that) Hate for you to order it and it not work but.... I think this will work -
|
||||
"Most folks are about as happy as they make their minds up to be" - Abraham Lincoln
|
||||
Sigundermykilt
Optics GrassHopper Joined: October/16/2012 Location: Uniontown, Pa. Status: Offline Points: 3 |
Post Options
Thanks(0)
|
|||
SVT_Tactical, Thank you for your response. The base the scope comes with is much like the
ACOG mount you suggested. I believe it would move the scope forward rather than rearward. I have taken your advice and am looking at other ACOG mounts that I might modify by drilling to move the scope back. Thank you. Shawn |
||||
Shawn
|
||||
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |