Visit the SWFA.com site to check out our current specials. |
rra scope mount |
Post Reply |
Author | |
skeetlee
Optics Apprentice Joined: February/15/2007 Location: United States Status: Offline Points: 67 |
Post Options
Thanks(0)
Posted: February/17/2007 at 12:21 |
i just purchased a one piece rra scope mount. have any of you fellas used this mount? what do you think of it? lee
|
|
Dale Clifford
Optics Jedi Knight Joined: July/04/2004 Location: United States Status: Offline Points: 5087 |
Post Options
Thanks(0)
|
Which one?
|
|
skeetlee
Optics Apprentice Joined: February/15/2007 Location: United States Status: Offline Points: 67 |
Post Options
Thanks(0)
|
did not know there were more than one. it was 50$ if that helps. one piece base with ring built to it.
|
|
Dale Clifford
Optics Jedi Knight Joined: July/04/2004 Location: United States Status: Offline Points: 5087 |
Post Options
Thanks(0)
|
The single high riser with the mounts? No never used it before, but having used several other brands before be careful that the rings do not compress the scope. Some are not round and will "pinch" the scope marring it. Also I usually build a "stop" in risers, by drilling a hole the width of the picatinny or weaver and then inserting a roll pin such that the riser has no forward or back play.
|
|
thinkingman
Optics Apprentice Joined: January/13/2006 Status: Offline Points: 93 |
Post Options
Thanks(0)
|
I have one. It is the only mount I've used with a picatinny and it goes on very straight. I have mounted 3 scopes on my RRA and each one required only very minor changes in yaw. I think the mount is very sturdy, has 4 screws for each ring, 8 total. The rings themselves are pretty wide, probably over an inch...lots of surface to reduce any crimp and lots of friction. Good setup, but again, I've only used one. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |