New Posts New Posts RSS Feed - Need some scope ID help
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Check GunBroker.com for SWFA's No Reserve and No Minimum bid firearm auctions.

Need some scope ID help

 Post Reply Post Reply   Topic Search Topic Search  Topic Options Topic Options
Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: December/31/2011 at 14:00
lucznik View Drop Down
Optics Master
Optics Master


Joined: November/27/2004
Location: United States
Status: Offline
Points: 1436
First some description:
I just got an older Burris scope from my dad.  It says 3x-9x Burris on the side.  There are a couple of metallic stickers on the ocular bell but, the scope was painted over many years ago as part of a camoflauging scheme and the stickers are now unreadably covered in paint. 
 
The scope has an interesting reticle.  The magnification ring has, on the "top" side of the ring,  numbers corresponding to the scopes magnification.  Underneath these magnification numbers, on the "bottom" side of the ring, there are yardage figures starting at 200 and increasing in 50 yd increments and topping out at 500 yds.   Looking through the scope, at 3x it is a basic Duplex reticle with two additional horizontal lines located at the bottom of the FoV for a total of three horizontal lines.  Then, when you turn the magnification ring, the main reticle splits and gives two seperate reticles that increase in their distance one from the other as you increase magnification - so that now you actually have four seperate horizontal lines. 
 
So, my questions are probably pretty obvious.  Do any of you know anything about this scope?  What are the two horizontal stadia at the bottom of the FoV for?  How does one use the main crosshair(s)?  Why do they split?  You know, the usual.
 
Any help is greatly appreciated.
Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: December/31/2011 at 20:59
helo18 View Drop Down
Optics Jedi Knight
Optics Jedi Knight
Avatar

Joined: December/02/2006
Location: Montana
Status: Offline
Points: 5429
Sounds like one of the original Burris Signatures.  I saw one similar to that, but it only had two lines, and a dot that slid when you turned the ring.  You would turn it till the deers body fit in the two lines, and then use the dot as the aiming point.  

I am guessing that yours does some sort of the same thing.
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Similar Threads: "Need some scope ID help"
Subject Author Forum Replies Last Post
Trijicon 3-9x40 scope ID help needed waltham41 Rifle Scopes 10
Leupold Scope ID help needed ASAP! nitis Rifle Scopes 13
Seemingly Rare Binoculars: Need Help with ID! Nightsurf13 Binoculars 2
Scope ID help Pioneer Rifle Scopes 1
Need help identifying vintage scope 67goingthing Rifle Scopes 4
Help!Need to know if my scope would work on a rife V8Mechanic Rifle Scopes 6
Need help with multi purpose scope estes640 Rifle Scopes 25
Need help with .460 scope decision TaylorMiller Rifle Scopes 4
Need help with Remi 597 and tasco varmint scope Shooter01 Varmint Scopes 1
Need help Choosing New Scope! Mtansey Rifle Scopes 12


This page was generated in 0.422 seconds.