Visit the SWFA.com site to check out our current specials. |
Kind of rifle and bases needed? |
Post Reply |
Author | |
sakomato
Optics Master Joined: February/28/2008 Location: Houston Status: Offline Points: 1166 |
Post Options
Thanks(0)
Posted: January/11/2011 at 22:46 |
Need to figure out what kind of rifle this is so I can get bases and rings
it is an 30 Gibbs from the mid 40's from what I'm told
Worst case scenario then maybe just some rings that will fit the existing base which is a Buehler 1 piece
|
|
Guns only have 2 enemies, rust and politicians
|
|
300S&W
Optics God Joined: January/27/2008 Location: Burlington,WV Status: Offline Points: 10592 |
Post Options
Thanks(0)
|
HEY,Bob.
It's a 1917 Enfield. As far as the mounts go it will depend on how the receiver was cut. My understanding is that if both the front and rear of the receiver are the same height (which it looks to be) then it could match Remington Model 30 bases (f and r #11) after another hole was d/t in the rear. If the heights are different then it could take either Remington 721 (f-#35 and R-#36) or Winchester Model 70 bases (f-#46 and r-#47) after another rear hole is d/t.
A .30 Gibbs,huh? COOL!!!!!!!! Edited by 300S&W - January/12/2011 at 04:59 |
|
"I ain't got time to bleed!"
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |