OpticsTalk by SWFA, Inc. Homepage SWFA     SampleList.com
Forum Home Forum Home > Mounts & Accessories > Rings and bases
  New Posts New Posts RSS Feed - B-Square Mounts for SS on AR
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Visit the SWFA.com site to check out our current specials.

B-Square Mounts for SS on AR

 Post Reply Post Reply
Author
Message
UnSafe View Drop Down
Optics GrassHopper
Optics GrassHopper


Joined: September/24/2005
Location: United States
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote UnSafe Quote  Post ReplyReply Direct Link To This Post Topic: B-Square Mounts for SS on AR
    Posted: September/24/2005 at 14:25
What height of B- Square mounts would I need for a Super Sniper 16x scope on a flat top AR ?
Back to Top
dilligaf View Drop Down
Optics Apprentice
Optics Apprentice
Avatar

Joined: January/17/2005
Location: United States
Status: Offline
Points: 231
Post Options Post Options   Thanks (0) Thanks(0)   Quote dilligaf Quote  Post ReplyReply Direct Link To This Post Posted: September/25/2005 at 16:15

I'd recommend at leaste a medium height ring to give you the proper cheek weld. If you are going to use BUIS and want to co-witness in the lower 1/3 rather then in the center of the scope I'd go with a tall ring.

 

Joe

Back to Top
UnSafe View Drop Down
Optics GrassHopper
Optics GrassHopper


Joined: September/24/2005
Location: United States
Status: Offline
Points: 2
Post Options Post Options   Thanks (0) Thanks(0)   Quote UnSafe Quote  Post ReplyReply Direct Link To This Post Posted: September/27/2005 at 09:13

Thanks!

 I'm in the planning stages of an AR varmint rifle build, and prefer fixed power scopes. The SS 16x fits my needs, I hope it lives up to the claims of clarity and brightness. The B-Square rings seem to offer a sturdy mount without the excessive cost of other rings. 

Back to Top
Ring Master View Drop Down
Optics Apprentice
Optics Apprentice
Avatar
Master of the Rings

Joined: December/03/2004
Location: Oregon USA
Status: Offline
Points: 198
Post Options Post Options   Thanks (0) Thanks(0)   Quote Ring Master Quote  Post ReplyReply Direct Link To This Post Posted: October/11/2005 at 12:49

I have one of the SS 16x scopes and think its one of the best scopes for the money you can get. There will be one or two in my future. As for AR ring height, be careful. The ideal placement for your cross hairs is in the center of where the peep would have been. The height in this case would be about 9/10" or .900 above the Picatinny rail or the flat top on the AR15. Warne 217LM Ultra high Maxima or 617M Tactical ring (over kill for an AR) will work fine. These rings were designed just for that rifle. Good luck.

 

RM 

Ron
NRA Life Member
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 4.813 seconds.