![]() |
|
Muzzeloader scope? |
Post Reply
|
Page 12> |
| Author | ||||
brav302
Optics GrassHopper
Joined: November/13/2008 Location: South Carolina Online Status: Offline Posts: 35 |
Quote Reply
Topic: Muzzeloader scope?Posted: October/30/2009 at 20:25 |
|||
|
Will any scope work on a muzzeloader, or does a muzzeloader need a muzzeloader scope? The reason I ask is I seem to be having trouble zeroing in my muzzeloader. I put a Kahles 2-7x36 on it.
|
||||
![]() |
||||
hawkman
Optics Apprentice
Joined: September/04/2009 Location: Tenn Online Status: Online Posts: 112 |
Quote Reply
Posted: October/30/2009 at 20:34 |
|||
|
||||
|
I'd rather be tried by 12 than carried by 6.
|
||||
![]() |
||||
brav302
Optics GrassHopper
Joined: November/13/2008 Location: South Carolina Online Status: Offline Posts: 35 |
Quote Reply
Posted: October/30/2009 at 20:45 |
|||
|
Its a new setup. I'm trying some differant bullets tomorrow. The scope worked great on my 308. I was just woundering if there might be something with the recoil causing it.
|
||||
![]() |
||||
hawkman
Optics Apprentice
Joined: September/04/2009 Location: Tenn Online Status: Online Posts: 112 |
Quote Reply
Posted: October/30/2009 at 20:49 |
|||
|
I wouldn't think so. Is this your first time with a ML. You just have to work up a load that the gun likes. Different types of bullets, bullet grain, grains of powder. Sometimes they can be a headache.
|
||||
|
I'd rather be tried by 12 than carried by 6.
|
||||
![]() |
||||
hawkman
Optics Apprentice
Joined: September/04/2009 Location: Tenn Online Status: Online Posts: 112 |
Quote Reply
Posted: October/30/2009 at 20:53 |
|||
|
Will the gun group at all or is it throwing the bullets all over the paper. Without a group there is no since in adjusting the scope until a group is achieved.
|
||||
|
I'd rather be tried by 12 than carried by 6.
|
||||
![]() |
||||
Urimaginaryfrnd
Optics Jedi Knight
Resident Redneck Joined: June/20/2005 Location: Iowa Online Status: Offline Posts: 5879 |
Quote Reply
Posted: October/31/2009 at 00:29 |
|||
|
Any scope will work but there is an advantage to one with a balistic reticle as the trajectory is fairly radical. I have a Nikon Omega on mine and they make a new model:
I have a couple of suggestions to make this less painful. Use Barnes sabbots preferably the 250 grain with the blue plastic tip but any of them will shoot a lot better than the competitions bullets. Powder charges in modern rifles can go from 80 grains to 150 grains of powder. If you use pre formed pellets two pellets is 100 grains and three pellets is 150 grains. I have one rifle that will group well with 150 grains but all of the other muskets I have shot did much better with 120 grains of loose Tripple 7 FFG powder. I would try some at 100 and some at 120 and see what groups best. It is VERY important to run a wet patch then a dry patch down the bore after every shot to maintain a consistent seating depth - failure to do this will result in a pattern that looks like buckshot. Sooner or later you will run a dry patch down the bore and it will stick there and not come out - simply pour a little powder solvent down the bore and once the patch is wet it will come right out. Never forget to put grease on the threads of the breach plug or it will ruin the rifle. I find that muskets shoot better after some use than they do brand new.
|
||||
|
>>>=============>
OT's Least Politically Correct |
||||
![]() |
||||
brav302
Optics GrassHopper
Joined: November/13/2008 Location: South Carolina Online Status: Offline Posts: 35 |
Quote Reply
Posted: October/31/2009 at 07:06 |
|||
|
Thanks for all the info. I was shooting 240 gr hornady XTP with 2 pyrodex pellets. Today I'm going to try 2 pyrodex pellets with 200 gr TC shock wave sabots. At one point I shot one decent 3 shot group then they started getting all over the place. Some off the paper.
|
||||
![]() |
||||
martin3175
Optics Master
Joined: January/19/2005 Location: Maryland Online Status: Offline Posts: 2607 |
Quote Reply
Posted: October/31/2009 at 11:49 |
|||
|
Are you cleaning the bore after each shot ? perhaps changed primers ( stick with muzzleloader specific 209's ) ? double checked your mounts and rings are snug ? are your pellets a couple years old - could have absorbed moisture from storage ? What kind of muzzleloader is it ?
|
||||
![]() |
||||
brav302
Optics GrassHopper
Joined: November/13/2008 Location: South Carolina Online Status: Offline Posts: 35 |
Quote Reply
Posted: October/31/2009 at 18:47 |
|||
|
Looks like it was the bullets. With these it will shoot holes touching at 100 yrds.
|
||||
![]() |
||||
hawkman
Optics Apprentice
Joined: September/04/2009 Location: Tenn Online Status: Online Posts: 112 |
Quote Reply
Posted: October/31/2009 at 18:50 |
|||
|
Good deal. Figured it had something to do with the ammo or load.
|
||||
|
I'd rather be tried by 12 than carried by 6.
|
||||
![]() |
||||
anweis
Optics Journeyman
Joined: January/29/2006 Online Status: Offline Posts: 658 |
Quote Reply
Posted: November/01/2009 at 06:29 |
|||
|
the 1.65-5x36 Nikon Omega is THE muzzleloader scope.
|
||||
![]() |
||||
anweis
Optics Journeyman
Joined: January/29/2006 Online Status: Offline Posts: 658 |
Quote Reply
Posted: November/01/2009 at 06:32 |
|||
|
You need to be consistent. Clean the same way between shots, fire a primer between shots, put the same pressure on the bullet when seating, etc. Loose powder is almost always more accurate. Most muzzleloaders need a fouling shot before starting to group.
|
||||
![]() |
||||
Post Reply
|
Page 12> |
| Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |