New Posts New Posts RSS Feed - Burris Signature ring inserts
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Check for SWFA's No Reserve and No Minimum bid firearm auctions.

Burris Signature ring inserts

 Post Reply Post Reply   Topic Search Topic Search  Topic Options Topic Options
Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: July/16/2004 at 15:38
shelby1941 View Drop Down
Optics GrassHopper
Optics GrassHopper

Joined: June/28/2004
Location: United States
Status: Offline
Points: 5

Today I mounted a Weaver Grand Slam 6x20x44 on an Anschutz 1710 using Burris Signature rings.  I had to run the vertical adjustment all the way up and still was shooting approx one inch low at 50 yards.  Can someone please advise as to what size inserts to use to get me back to middle of adjustment range.  Thanks in advance.

Shelby Chastain

Post Options Post Options   Thanks (0) Thanks(0)     Back to Top Direct Link To This Post Posted: July/16/2004 at 19:26
Chris Farris View Drop Down

Joined: October/01/2003
Location: Texas
Status: Offline
Points: 7759

First make sure you are using the 0's in both rings.  Second re-center your reticle.  Turn the adjustment until it stops then count revolutions back the other way until it stops, divide by two and turn it back the other way.  Repeat for your windage adjustment.  Determining which shims and where to put them is tricky and is 100% easier with a boresighter BTW.  IF you are off that much my first concern would be to determine why.  Is the mount faulty, receiver out of spec. or barrel bent, etc.?  Try reversing the rings, in other words move the rear one to the front and vice versa, if the opposite problem occurs then you know one of the rings has a problem.  If that gun uses a base and it can be reversed do the same with it.  Try another scope and see if it does it.  Eventually you will narrow down what the problem is through the process of elimination.  The Signature rings will not fix your problem but they will compensate for it and judging by your zero I would say to use the 20's.


Use the inserts with the (+) in the bottom of the front ring for additional down movement.


Use the inserts with the (+) in the bottom of the rear ring for additional up movement.

 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Similar Threads: "Burris Signature ring inserts"
Subject Author Forum Replies Last Post
Burris XTR Signature Rings Ernie Bishop Rings and bases 3
WTB Burris Signature Zee 30mm Rings slowr1der Rings and bases 2
Burris Signature Zee Rings Txhillbilly Rings and bases 1
Burris Signature 3-9X40 (pre signature select) idahotrophyhunter Rifle Scopes 1
Which Base For Burris Signature Rings blacktails Rings and bases 0
Are these Burris Signature Zee rings installed cor slowr1der Rifle Scopes 4
Recommended torque for Burris Signature Zee rings Vermin93 Rings and bases 1
Burris Signature Rings army_eod Rings and bases 0
Burris Signature 30mm Rings imprez55 Rings and bases 5
Burris Signature Double Dovetail Rings STWSniper Rings and bases 2 4/8/2005 2:46:08 PM

This page was generated in 0.359 seconds.